PPR Angle Radiator Brass Ball Vale Pipe Fittings
Angle valve is the angle type valve, angle valve and ball valve is similar to the structure and properties of the amendment comes from the ball valve. The difference between the ball valve that exports and imports Angle into a 90 degree angle.
***Feature of PPR Angle Radiator Brass Ball Vale:
1, the flow path is simple, smaller dead zone and vortex area, scouring action by means of the media itself, which can effectively prevent the clogging of the media, which has good self-cleaning properties;
2, flow resistance, flow coefficient than the single seat valve, the valve seat is equivalent flow coefficient;
It is suitable for high viscosity fluid containing suspended particulate matter and the case, or at right angles to the pipe where required. Its flow is generally the bottom into the side.
Under special circumstances can be reverse mounted, that flows into the bottom side out.
Triangle valve two kinds of hot and cold (blue, red flags to distinguish) the vast majority of the material is the same factory, hot and cold signs, mainly in order to distinguish which is hot and which is cold.
***The four main roles of PPR angle radiator brass ball valve:
① adapter from both inside and outside the outlet;
② pressure is too large, you can adjust the triangle above the valve, down a bit;
③ switch roles, if faucet leaks occurred, triangle valve can be turned off without having to shut the main valve in the house;
④ nice. Therefore, new home decoration in general are essential plumbing fittings, so the designers will decorate the house mentioned.
***Installation Technical Precautions:
When temperature drops under 0ºC in winter,precaution must be taken to prevent possible cracking of pipes if the pipes are hit by external force.
The pipes shall be away from heat when stored for long time,direct sunshine shall be avoiced during product transportation or storage.
PP-RC pipe has big expansion coefficient,technical measures must be taken to prevent the thermal deformation fo the pipe during the exposed or covered pipe layout.
One support or hanger (pipe buckle seat)must be installed every 400mm in exposed layout or non-linear covered layout.
During installation,relevant design & installation codes must be followed,the construction workers must be trained and carry their certification badges at work.